:	Nov 8, 2005

.

: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands. Raise and support the vehicle.

.

Remove the wheel and tire.

.

Remove the wheel knuckle.

.

Remove the adjuster and return spring.

.

Remove the primary brake shoe.   Remove the hold-down spring and retaining pin.   Pivot the shoe to release it from the spreader plate and return spring.

.

Remove the spreader plate and spring.

.

Remove the return spring.

.

Remove the secondary brake shoe.   Remove the hold-down spring and retaining pin.   Disconnect the parking brake cable retaining spring from the brake shoe lever.

.

Using the special tools, remove the drive flange.

.

Remove the brake disc dust shield.   Remove the 3 screws.

.

Using the special tools, remove the wheel bearing.   Remove the circlip.

.

Clean the components.

.

Using the special tools, install the wheel bearing.

.

: Make sure that the bearing seal is not damaged when installing the circlip. Install the circlip.

.

Install the brake disc dust shield.   Tighten the bolts to 9 Nm (7 lb.ft).

.

: Do not use compressed air to clean brake components. Dust from friction materials can be harmful if inhaled. Clean the backing plate and apply grease to the brake shoe contacts.

.

Clean the adjuster and set it to its minimum extension.

.

Install the secondary brake shoe.   Connect the parking brake cable retaining spring to the brake shoe lever, making sure the spring is not twisted.   Install the hold-down spring and retaining pin.

.

Install the primary brake shoe.   Install the spreader plate and the spring.   Install the return spring.   Install the hold-down spring and retaining pin.

.

Install the return spring.

.

Install the brake shoe adjuster.

.

Using the special tools, install the drive flange.

.

Install the wheel knuckle.